Wi-Fi functionality allows for two scenarios:
- In Client mode the Sevio Router connects directly to a Wi-Fi network at the installation site for internet access. A mobile hotspot on a smartphone can also provide this connection.
- In Access Point mode, any device with a wireless card can access the Sevio Router's LAN (automation network). For further details, please refer to the Wi-Fi Access Point article.
Sevio Routers equipped with the Wi-Fi interface can be connected to 2.4 GHz Access-Points supporting WPA or WPA2 security protocols with Pre-Shared-Key (authentication key or password for network access). WEP encryption, due to its obsolete and no longer secure nature, is not supported by Sevio Router.
This button enables and disables the Wi-Fi interface.
This parameter displays the connection status and, if active, the signal strength.
The button can be used to refresh the signal strength display.
For further details, please refer to the Wi-Fi Access Point article.
The Router's regional configuration ensures compliance with Wi-Fi radio frequency regulations.
In Auto mode, the Sevio Router synchronizes its receiving frequency with the connected Access Point.
In Auto mode, the Sevio Router matches the Access Point's receiving frequency.
- Enabled - if a DHCP Server is on the installation site's network, the Sevio Router automatically receives the necessary network settings. Click to view the assigned network configuration.
- Disabled - the network parameters require manual configuration.
- IP Address: the IPv4 address assigned to the interface, within the network's address range.
- Prefix.: indicates the length of the network prefix in CIDR notation.
- Netmask: this parameter verifies the IP address and prefix length.
Ensure the WAN IP address (whether set manually or obtained from DHCP) differs from the IP address of any Device on your automation network.
The Gateway is essential for communication between Devices on the local network and Devices on other networks.
This button enables and disables the Wi-Fi interface.
This parameter displays the connection status and, if active, the signal strength.
The button can be used to refresh the signal strength display.
For further details, please refer to the Wi-Fi Access Point article.
The Router's regional configuration ensures compliance with Wi-Fi radio frequency regulations.
In Auto mode, the Sevio Router matches the Access Point's receiving frequency.
- Enabled - if a DHCP Server is on the installation site's network, the Sevio Router automatically receives the necessary network settings. Click to view the assigned network configuration.
- Disabled - the network parameters require manual configuration.
- IP Address: the IPv4 address assigned to the interface, within the network's address range.
- Prefix.: indicates the length of the network prefix in CIDR notation.
- Netmask: this parameter verifies the IP address and prefix length.
Ensure the WAN IP address (whether set manually or obtained from DHCP) differs from the IP address of any Device on your automation network.
The Gateway is essential for communication between Devices on the local network and Devices on other networks.
Characters Not Accepted by Wi-Fi Client
Wi-Fi Client and station do not accept non-ASCII characters:
| Accented characters | Á, é, ü, ñ, ç, etc. |
| Special symbols | €, ©, ®, ™, etc. |
| Extended punctuation | « », “ ”, –, —, etc. |
| Advanced mathematical symbols | ∑, ∞, √, ≠, etc. |
| Non-Latin characters | Кириллица (Cyrillic), العربية (Arabic), 中文 (Chinese), etc. |
| Emojis and graphic symbols | ☺, ☻ , etc. |
| Non-visible spacing and punctuation | Non-breaking space (\xA0), thin space, em space, etc. |
| Technical and graphical symbols | ⌂, ░, ▒, ▓, etc. |