This article provides a guide to using the Sevio System in association with Mitsubishi Electric® - GX Works2 with Ethernet PLC - Q Series.


Trademarks

Sevio is a Sevio S.r.l. trademark.
Mitsubishi Electric®, GTD3, GX, RT ToolBox3, RT ToolBox2, FR Configurator2, FR Configurator Mobile and MR Configurator2 are Mitsubishi Electric Corporation brands. Other product names and brands are registered brands or trademarks of their respective owners.


Requirement

The fundamental requirements for the use of the Sevio System combined with Mitsubishi Electric®:

  • The Sevio Router.
  • The Registration Sheet (supplied along with the Sevio Router).
  • A Mitsubishi Electric® PLC, HMI, Robot, Inverter, Servo with Ethernet connectivity.
  • A PC with an up-to-date web browser and the following software installed:
    • GX Works2.
    • GXWorks3.
    • GTD3.
    • RT ToolBox3, RT ToolBox2.
    • FR Configurator2, FR Configurator Mobile.
    • MR Configurator2.
  • A VPN Client configured and connected (see Workstation Management).
  • An internet access.


Preliminary confiruation

Go to PLC parameters, e.g. 192.168.3.39.

Set up as Default Router IP address, the Sevio Router  LAN IP Address assigned (e.g. 192.168.3.1). For further details, please refer to the Sevio Router parameters article.


Remote Access

Go to the PLC IP address, select Connection1, Ethernet Board and PLC Module.

Set up the remote PLC IP Address:

Then press OK to confirm.

Execute Connection Test > OK.

From this moment on it is possible to perform all online activities.