This article provides a guide to using the Sevio System in association with Mitsubishi Electric® - GX Works3 - iQ-F products.


Trademarks

Sevio is a Sevio S.r.l. trademark.
Mitsubishi Electric®, GTD3, GX, RT ToolBox3, RT ToolBox2, FR Configurator2, FR Configurator Mobile are Mitsubishi Electric Corporation registered brands. Other product names and brands are registered brands or trademarks of their respective owners.


Requirement

The fundamental requirements for the use of the Sevio System combined with Mitsubishi Electric®:

  • The Sevio Router.
  • The Registration Sheet (supplied along with the Sevio Router).
  • A Mitsubishi Electric® PLC, HMI, Robot, Inverter, Servo with Ethernet connectivity.
  • A PC with an up-to-date web browser and the following software installed:
    • GX Works2.
    • GXWorks3.
    • GTD3.
    • RT ToolBox3, RT ToolBox2.
    • FR Configurator2, FR Configurator Mobile.
    • MR Configurator2.
  • A VPN Client configured and connected (see Workstation Management).
  • An internet access.


Preliminary configuration

Go to the Module Parameters/Ethernet Port, e.g. 192.168.3.104.

Set up as Default Gateway the Sevio Router LAN IP Address assigned (e.g. 192.168.3.1). For further details, please refer to the Sevio Router parameters article.


Remote access

Go to the PLC IP Address, select Online > Specify Connection Destination > Ethernet Board and PLC Module.

Set up the remote PLC IP Address:

Click OK.

Execute Connection Test.

From this moment on it is possible to perform all online activities.